GOLF, CURL & MORE
726 Dundas St., Woodstock, Ontario, Canada. N4S 1E7. 519-537-7496, 1-866-286-2875, rbmck@oxford.net
|
GOLF, CURL & MORE 726 Dundas St., Woodstock, Ontario, Canada. N4S 1E7. 519-537-7496, 1-866-286-2875, rbmck@oxford.net |
|
Model 770CFE irons
represent the first set of irons designed with a forged steel, CNC machined,
variable thickness face design
Very
forgiving, and extremely solid on off-center hits. #3, 4 (Carpenter 455 HS Steel); #5, 6, 7 (17-7 Stainless Steel); #8, 9,
PW, SW (304 Soft Stainless Steel) (Right hand only)
The 770CFE irons are designed with a variable thickness forged face to offer golfers a little higher ball-speed-to-swing speed ratio than is possible with a conventional thick face iron design, but also to offer golfers a much better off-center hit forgiveness because of the variable thickness face design. Because
irons increase in loft progressively through the set, the actual force of
deflection of the face will decrease as loft increases. To help maximize the
amount of face deflection as loft increases in the irons, the forged variable
thickness face design changes in face material composition and thickness. Thus,
the #3 and 4 iron faces are forged from Carpenter 455 high strength steel and
are designed with a variable thickness of 2.4mm/1.9mm.Then the #5, 6, and 7 iron
faces are forged from 17-7 stainless steel and machined to a variable thickness
of 2.5mm/2.0mm. And the #8 through wedge faces are forged from soft 304
stainless and machined to a variable thickness of 2.6mm/2.2mm. In
addition, as loft increases in a set of irons, the actual position of impact on
the face will change. To accommodate this natural tendency in iron impact
position, the thicker center section of the faces changes in position through
the set. All
770CFE faces are CNC machined after forging to ensure precision in the face
design. The CNC machining marks can be seen on the back of each face. The
body of each 770CFE iron is designed to maximize the area of the face available
for face deflection, as well as to move as much of the weight of each head
further back from the face and shaft centerline to assist in launch angle. The sole design of the 770CFE is designed to keep a large amount of mass low, but by beveling the back edge of the sole the sole width is not so wide to ensure proper sole playability from all types of turf and lie conditions. 770CFE
irons are finished in a bright satin polish finish, with all faces CNC machined
for precision dimensional specifications. Home of " SINGLE CLUB PRICING " $ 99.99 STEEL, $ 119.99 GRAPHITE
Call for price: 1-866-286-2875 |
|
This website is best viewed using Microsoft Internet ExplorerAll prices listed are in Canadian Funds. Shipping charges and applicable taxes are not included. Prices listed are subject to change without notice. Minimum order quantities may be required for some items. Golf, Curl & More, 726 Dundas St. Woodstock, Ontario, Canada, N4S 1E7 1-866-286-2875, 519-537-7496 Fax: 519-537-8050, www.golfcurlandmore.com rbmck@oxford.net |
